Fan/Heat Sink Assembly - HP EliteBook x360 1030 G8 Maintenance And Service Manual

4. Remove the system board (2) by sliding it up and forward at an angle.
Reverse this procedure to install the system board.

Fan/heat sink assembly

To remove the fan/heat sink assembly, use these procedures and illustrations.
Table 5-12 Fan/heat sink assembly descriptions and part number
Description
Fan/heat sink assembly (includes replacement thermal material and fan cables)
Before removing the fan/heat sink assembly, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the system board (see
Remove the fan/heat sink assembly:
1. Disconnect the fan cables (1) from the system board.
2. In the order indicated on the fan/heat sink assembly, remove the four captive Phillips screws (2) that
secure the fan/heat sink assembly to the system board.
3. Loosen the four captive Phillips screws (3) that secure the fan/heat sink assembly to the system board.
Preparation for disassembly on page
Bottom cover on page
Battery on page 36).
System board on page
35).
52).
Component replacement procedures
Spare part number
M45823-001
35).
55