Connector Board - HP EliteBook x360 1030 G8 Maintenance And Service Manual

3. Remove the connector board cable (3).
Reverse this procedure to install the connector board cable.

Connector board

To remove the connector board, use this procedure and illustration.
Table 5-5 Connector board description and part number
Description
Connector board for use in models with WWAN
Connector board for use in models without WWAN
Before removing the connector board, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board the battery (see
4. Remove the WWAN module (see
Remove the connector board:
1. Remove the nano SIM tray (1) from the mini media card reader slot.
NOTE:
2. Disconnect the cable from the ZIF connector on the system board (1).
3. Remove the two Phillips M2.0 × 5.0 screws (3) that secure the connector board to the computer.
42 Chapter 5 Removal and replacement procedures for authorized service provider parts
Bottom cover on page
WWAN module on page
The nano SIM tray is available using spare part number M16053-001.
Preparation for disassembly on page
35).
39) .
Spare part number
M16050-001
M23394-001
35).
Battery on page 36).