Overview Of Versions - ABB i-bus KNX IPS/S 3.5.1 Product Manual

ABB i-bus ® KNX
General
The power supply can be implemented via PoE (Power over Ethernet) according to IEEE 802.3af class 1
or via a supply voltage. If both options are connected simultaneously, PoE will be used.
The ABB i-bus
for the IP Interface Secure (see chapter 4.2,
An ETS app (ABB Firmware Update 2.0) is available for the firmware update. If KNX Secure mode is not
activated for the devices, a firmware update can also be performed with the i-bus
During the update process, the KNX bus (TP) must be connected in addition to the IP network (LAN).
Otherwise, the update process will fail.
It must be ensured that no voltage failure (KNX or IP) occurs during the update process, otherwise the
device can be destroyed.
1.8.1

Overview of versions

Properties of the IP Interface
Number of tunneling servers
IP discovery (i-bus
Firmware update with i-bus
Firmware update with ABB Firmware Update 2.0
Power over Ethernet
KNX Secure
* Only if the device is not operated in KNX Secure mode
® Tool, which is capable of detecting the Interface in the network (IP discovery), is available
® Tool)
® Tool
The i-bus® Tool).
Device IPS/S 3.1.1
IP Interface/1.1
Application
ETS from ETS 3
1


-

-
IPS/S 3.5.1 | 9AKK107680A8655 EN Rev. A 9
® Tool.
IPS/S 3.5.1
IP Interface
Secure/1.0
from ETS 5
5

*


