Table of Contents
Advertisement
ABB i-bus
®
KNX
Commissioning
The IP address can be defined in the IP Properties window.
The following options are available for setting the IP address:
Options:
Obtain an IP address automatically: In the default setting, the IP Interface Secure expects the
•
assignment of an IP address by a DHCP (dynamic host configuration protocol) server. This server
responds to a request by assigning a free IP address to the device. If a DHCP server is not available
in the network, the device starts an auto IP procedure. It assigns itself an address from the reserved
range for auto IP addresses (169.254.1.0 to 196.254.254.255).
Refer to chapter 4.1.1.,
•
Use a static IP address: If no DHCP server is installed in the network or if the IP address should
remain the same, it can be assigned as static.
When assigning static IP addresses, ensure that each device receives a different IP address.
Note
The MAC address is read from the device after a download.
The MAC address is additionally labeled on the device, or it can be determined via the i-bus
3.3
Group objects
The IP Interface Secure IPS/S has no KNX group objects.
Obtain an IP address automatically
Use a static IP address
Assignment of IP
address, for information about DHCP.
IPS/S 3.5.1 | 9AKK107680A8655 EN Rev. A 21
®
Tool.
Advertisement
Table of Contents
