TECHFASS APS mini MREP 78 Series User Manual page 17

6.8.3 Deleting cards (codes) „above or below"
If a user loses his ID medium, it is usually impossible to delete the ID from the memory with
the procedure described in the previous chapter, since the medium is no longer available
(with an exception of entering the code at the keypad). Following procedure can be used for
deleting such ID. The procedure
before or right after the ID
Step 1
Read the programming card
(or enter the programming
code) for inserting: the reader
goes into programming
mode, which is indicated by
slow flashing of yellow LED.
Step 4 - A
For deleting an ID located
right before the ID used in
precious step,
programming card
deleting (or enter
programming code).
Pic.4 c): Deleting cards (codes) "above or below"
requires using an ID
medium, which should be deleted.
Step 2
Read the programming card
for inserting 5 times in a row
(or enter the programming
code); the reader will go into
Deleting cards "above or
below"
mode indicated by fast
flashing of yellow LED.
Step 4 - B
For deleting an ID located
right after
read the precious
for programming
the inserting
programming code).
Page 17
medium, which was inserted
the ID used in
step, read the
card for
(or enter the
Step 3
Read a card (or enter a code),
which is located in
module's memory
right before
or right after the card you wish
to delete. After this step the
module quickly flashes with
yellow LED.
Step 5
The reader module goes back
into standard operating
mode.
right
the