Table of Contents
Advertisement
When the reader module operates in the entry reader operating mode, the I/O Port (tab. 6 is
used as an output for controlling the entry reader buzzer.
Since the
FW version 5.09
implemented, enabling to
offers the
Wiegand data interface synchronization
6.6.3 Standard operating mode with IDS control
The
MREP 78
modules can be configured to the
In this mode the
WIEGAND interface
for control of the
IDS. The first relay of the WIO 22 module is copying the status of the reader
module door lock relay status, while the second relay is used for the IDS control.
When the reader module operates in the IDS control operating mode, the I/O Port (tab. 6) is
used for monitoring the IDS status. The interpretation of its status is: I/O Port active status
(= 0V signal from the IDS at the I/O Port) = IDS armed.
The IDS can be controlled with one of the following modes:
•
Status control
status is defined: output active = IDS disarmed / output inactive = IDS armed
•
– the IDS status (armed / disarmed) is switched by a pulse of the WIO 22
Pulse control
second relay, the width of the pulse can be defined in the range of 0 ÷ 25500 ms with
a 100 ms step
When using the Pulse control mode, the proper connection of the I/O Port for the IDS
status monitoring is required!
Detailed description of the IDS control function is described in chapter 8.
6.6.4 Wiegand output operating mode
The module can be configured into a standard reader with a
or 44 bits format for
EM Marin
setting first (see chapter 6.6), after that they are sent in the output format
When the reader module operates in this operating mode, the I/O Port (tab. 11) is used as
an input for monitoring an external device tamper status.
the reading synchronization of a
cancel the mutual disturbance
is used for controlling a
– the IDS is controlled by the status of the WIO 22 second relay, the
technology ID media. Read IDs are formatted with the previous
Page 13
couple of TECHFASS readers
of the modules. The reader module
in
SLAVE
mode.
Standard with IDS control
WIO 22 module, which is used
WIEGAND output
is
operating mode.
in 26, 32, 42
Advertisement
Table of Contents
