Alfa Network AWAP05O User Manual page 74

6
System Configuration
• New firmware file: Specifies the name of the code file on the server. The new
firmware file name should not contain slashes (\ or /), the leading letter of the file
name should not be a period (.), and the maximum length for file names is 32
characters for files on the wireless bridge. (Valid characters: A-Z, a-z, 0-9, ".", "-",
"_")
Firmware Upgrade Remote – Downloads an operation code image file from a
specified remote FTP or TFTP server. After filling in the following fields, click Start
Upgrade to proceed.
• New firmware file: Specifies the name of the code file on the server. The new
firmware file name should not contain slashes (\ or /), the leading letter of the file
name should not be a period (.), and the maximum length for file names on the
FTP/TFTP server is 255 characters or 32 characters for files on the wireless bridge.
(Valid characters: A-Z, a-z, 0-9, ".", "-", "_")
• IP Address: IP address or host name of FTP or TFTP server.
• Username: The user ID used for login on an FTP server.
• Password: The password used for login on an FTP server.
Restore Factory Settings – Click the Restore button to reset the configuration
settings for the wireless bridge to the factory defaults and reboot the system. Note
that all user configured information will be lost. You will have to re-enter the default
user name (admin) to re-gain management access to this device.
Reset wireless bridge – Click the Reset button to reboot the system.
If you have upgraded system software, then you must reboot the wireless
Note:
bridge to implement the new operation code.
CLI Commands for Downloading Software from a TFTP Server – Use the
command from the Exec mode and then specify the file type, name, and IP
file
address of the TFTP server. When the download is complete, the
6-24
copy tftp
command can
dir