Alfa Network AWAP05O User Manual page 55

using a DHCP server to configure IP addressing, use the CLI to manually configure
the initial IP values (page 5-2). After you have network access to the wireless bridge,
you can use the web browser interface to modify the initial IP configuration, if
needed.
If there is no DHCP server on your network, or DHCP fails, the wireless
Note:
bridge will automatically start up with a default IP address of 192.168.1.1.
DHCP Client (Enable) – Select this option to obtain the IP settings for the wireless
bridge from a DHCP (Dynamic Host Configuration Protocol) server. The IP address,
subnet mask, default gateway, and Domain Name Server (DNS) address are
dynamically assigned to the wireless bridge by the network DHCP server. (Default:
Disable)
DHCP Client (Disable) – Select this option to manually configure a static address for
the wireless bridge.
• IP Address: The IP address of the wireless bridge. Valid IP addresses consist of
four decimal numbers, 0 to 255, separated by periods.
• Subnet Mask: The mask that identifies the host address bits used for routing to
specific subnets.
• Default Gateway: The default gateway is the IP address of the router for the
wireless bridge, which is used if the requested destination address is not on the
local subnet.
If you have management stations, DNS, or other network servers located on
another subnet, type the IP address of the default gateway router in the text field
provided. Otherwise, leave the address as all zeros (0.0.0.0).
Advanced Configuration
6
6-5