Alfa Network AWAP05O User Manual page 71

CLI Commands for SNMP – Use the
global configuration mode to enable SNMP. To set read/write and read-only
community names, use the
command defines a trap receiver host. To view the current SNMP settings, use
host
the command.
show snmp
DUAL OUTDOOR(config)#snmp-server enable server
DUAL OUTDOOR(config)#snmp-server community alpha rw
DUAL OUTDOOR(config)#snmp-server community beta ro
DUAL OUTDOOR(config)#snmp-server host 10.1.19.23 alpha
DUAL OUTDOOR(config)#exit
DUAL OUTDOOR#show snmp
SNMP Information
============================================
Service State : Enable
Community (ro) : ****
Community (rw) : *****
Location : building-1
Contact : Paul
Traps : Enabled
Host Name/IP : 10.1.19.23
Trap Community : *****
=============================================
DUAL OUTDOOR#
snmp-server enable server
snmp-server community
Advanced Configuration
command from the
command. The
snmp-server
6
7-25
7-24
7-25
7-27
6-21