Table of Contents
Advertisement
6
System Configuration
----------------Security-----------------------------------
Closed System
Multicast cipher
Unicast cipher
WPA clients
WPA Key Mgmt Mode
WPA PSK Key Type
Encryption
Default Transmit Key
Static Keys :
Key 1: *****
Authentication Type
===========================================================
DUAL OUTDOOR#
The index and length values used in the key command must be the same
Note:
values used in the encryption and transmit-key commands.
CLI Commands for WEP over 802.1x Security – From the 802.11a or 802.11g
interface configuration mode, use the authentication command to select open
system authentication. Use the multicast-cipher command to select WEP cipher
type. Then set 802.1x to required with 802.1x command, and disable MAC
authentication with the mac-authentication command. To view the current 802.11g
security settings, use the show interface wireless g command (not shown in
example).
DUAL OUTDOOR(config)#interface wireless g
Enter Wireless configuration commands, one per line.
DUAL OUTDOOR(if-wireless g)#authentication open
DUAL OUTDOOR(if-wireless g)#encryption 128
DUAL OUTDOOR(if-wireless g)#multicast-cipher wep
DUAL OUTDOOR(if-wireless g)#end
DUAL OUTDOOR(config)#802.1x required
DUAL OUTDOOR(config)#no mac-authentication
DUAL OUTDOOR(config)#
6-54
: DISABLED
: WEP
: TKIP
: SUPPORTED
: DYNAMIC
: HEX
: 128-BIT ENCRYPTION
: 1
Key 2: EMPTY
Key 3: EMPTY
: SHARED
Key 4: EMPTY
7-66
7-73
7-74
7-76
7-35
7-39
Advertisement
Table of Contents
