Alfa Network AWAP05O User Manual page 60

6
System Configuration
Remote IP Address – IP address of the remote end of the PPPoE tunnel. (Must be
entered for static IP allocation mode.)
CLI Commands for PPPoE – From the CLI configuration mode, use the interface
ethernet command to access interface configuration mode. Use the ip pppoe
command to enable PPPoE on the Ethernet interface. Use the other PPPoE
commands shown in the example below to set a user name and password, IP
settings, and other PPPoE parameters as required by the service provider. The
pppoe restart command can then be used to start a new connection using the
modified settings. To display the current PPPoE settings, use the show pppoe
command from the Exec mode.
DUAL OUTDOOR(config)#interface ethernet
Enter Ethernet configuration commands, one per line.
DUAL OUTDOOR(if-ethernet)#ip pppoe
DUAL OUTDOOR(if-ethernet)#pppoe username mike
DUAL OUTDOOR(if-ethernet)#pppoe password 12345
DUAL OUTDOOR(if-ethernet)#pppoe service-name classA
DUAL OUTDOOR(if-ethernet)#pppoe ip allocation mode static
DUAL OUTDOOR(if-ethernet)#pppoe local ip 10.7.1.200
DUAL OUTDOOR(if-ethernet)#pppoe remote ip 192.168.1.20
DUAL OUTDOOR(if-ethernet)#pppoe ipcp dns
DUAL OUTDOOR(if-ethernet)#pppoe lcp echo-interval 30
DUAL OUTDOOR(if-ethernet)#pppoe lcp echo-failure 5
DUAL OUTDOOR(if-ethernet)#pppoe restart
DUAL OUTDOOR(if-ethernet)#end
DUAL OUTDOOR#show pppoe
PPPoE Information
======================================================
State
Username
Service Name
IP Allocation Mode
DNS Negotiation
Local IP
Echo Interval
Echo Failure
======================================================
DUAL OUTDOOR#
6-10
: Link up
: mike
: classA
: Static
: Enabled
: 10.7.1.200
: 30
: 5
7-61
7-54
7-58
7-59
7-59
7-54
7-57
7-58
7-55
7-56
7-56
7-60
7-60