Alfa Network AWAP05O User Manual page 59

PPP over Ethernet – Enable PPPoE on the RJ-45 Ethernet interface to pass
management traffic between the unit and a remote PPPoE server. (Default: Disable)
PPPoE Username – The user name assigned for the PPPoE tunnel. (Range: 1-63
alphanumeric characters)
PPPoE Password – The password assigned for the PPPoE tunnel. (Range: 1-63
alphanumeric characters)
Confirm Password – Use this field to confirm the PPPoE password.
PPPoE Service Name – The service name assigned for the PPPoE tunnel. The
service name is normally optional, but may be required by some service providers.
(Range: 1-63 alphanumeric characters)
IP Allocation Mode – This field specifies how IP adresses for the PPPoE tunnel are
configured on the RJ-45 interface. The allocation mode depends on the type of
service provided by the PPPoE server. If automatic mode is selected, DHCP is used
to allocate the IP addresses for the PPPoE connection. If static addresses have
been assigned to you by the service provider, you must manually enter the assigned
addresses. (Default: Automatic)
• Automatically allocated: IP addresses are dynamically assigned by the service
provider during PPPoE session initialization.
• Static assigned: Fixed addresses are assigned by the service provider for both the
local and remote IP addresses.
Local IP Address – IP address of the local end of the PPPoE tunnel. (Must be
entered for static IP allocation mode.)
Advanced Configuration
6
6-9