For Windows 95 Users; For Windows Nt And Other Non-Pnp Users - Zoom 2812 Owner's Manual

56kbps/v.34 data with 14.4kbps fax

Hide thumbs Also See for 2812:

Table of Contents

software configuration is possible, as discussed in the

IMPORTANT NOTICE on page 12.

•

Windows NT and other non-Plug and Play com-

puters should use hardware COM port assignment.

For Windows 95 Users

We strongly recommend that you let Plug and Play con-

figure your faxmodem for you. At J2, the jumper should

be in the default position, over the right and center pins:

The jumper on J1 also should be in the default position,

in the top-left corner. (It doesn't matter where the

jumpers are at J3.)

If you want to set the port and IRQ manually, move the

jumper at J2 to the left and follow the instructions in

Port and IRQ Settings on page 47.

First follow the instructions beginning on page 22.

Setting Up Your Internal Faxmodem with Jumpers.

Then m ake sure the J2 jumper is over the left and center

pins. This disables the Plug and Play feature on the

board:

Set the COM port and IRQ jumpers according to the

instructions in Port and IRQ Settings below. Check your

Windows Help files and documentation for instructions

on determining available resources.

56K Faxmodem Owner's Manual

Table of Contents

Table of Contents

2819 2818 2822 2901 2826 2929 ... Show all