Zoom 2812 Owner's Manual page 36

NOTE 1: You may find it necessary or helpful to include
S95=44 in your initialization string. This enables
the responses CARRIER (telephone line speed)
and PROTOCOL, as well as CONNECT
(faxmodem-to-computer speed).
NOTE 2: Some software allows these commands to be
added to the list of dial prefixes.
There are other configurations that can be forced as well.
If you need to select a particular configuration, use the
AT command strings shown below. You can always return
to the modem's default configuration by typing
pressing the Enter key, but remember that if you do that,
the modem will not have received the commands in your
software's initialization string, as it normally would. Using
the ATZ command overcomes this problem if you have
saved all of your setup parameters in nonvolatile memory.
(To save setup parameters in nonvolatile memory in AT
terminal mode: Type
tings you choose, followed by
Enter. For example, if you type
press Enter, the
&C1
stored in Profile 0. See Appendix E for the table of AT
commands.)
To force...
MNP5/MNP4 operation
LAPM only
MNP4 only
MNP 10 operation
"Normal" operation (The fax-
modem will communicate with-
out any error correction or data
compression, but will retain
speed buffering and auto-speed
negotiation. It should not be
confused with the "standard"
configuration.)
36
followed by the parameter set-
AT,
or
&W0 &W1
AT &C1 &D2 &W0
and &D2 parameter settings are
Type these
commands and press
Enter
AT \N5
AT \N4
AT \N5 %C0
AT –K1 –SEC=1
AT \N0
56K Faxmodem Owner's Manual
and
AT &F
, and press
and