Din Rail Mount - National Instruments FieldPoint FP-1600 Quick Start Manual

fpoint cd.qxd 11/13/00
2
Install the Terminal Base(s)
CAUTION: Terminal bases must be connected to the network module
before applying power to the module. Do not connect or disconnect
terminal bases while power is applied to the network module.

DIN Rail Mount

A. Unlock rail clip.
B. Press base onto rail.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
1:23 PM Page 3
Panel Mount
A. Use template that came with your
accessory to drill pilot holes.
B. Connect terminal base to network
module connector, being careful not
to bend any connector pins.
C. Fasten terminal base to panel.
3