Table of Contents
Advertisement
TL3700 Series
Tubular Lockset
Installation Instructions
6
Square Rose (cont .)
b
Package Contents
Figure 1 Description
1
2
3
4
5
6
7
6
Square Rose (cont .)
c
Installation
1. Install lock per instructions starting on page 5.
a.
2. Position square mounting plate over spring housing as seen in Figure 1.
3. Drill two centered pilot holes for the #6 mounting screws in the upper right and lower left portions of
the square mounting plate.
4. Loosely attach mounting plate to both sides of the door with screws.
5. Square top surface of mounting plate to edge of door.
NOTE: The square edge MUST be on the flat surface of the square mounting plate for proper leveling.
6. Tighten mounting screws.
7. Press rose onto mounting plate, fasten lever with set screw.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2012, 2019, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
1
3
5
2
4
Lever
Set Screw
Rose Assembly
Mounting Post
Mounting Post Screw
Mounting Plate Assembly
O/S Thru-Bolt Plate Assembly
TL3750 only
Square rose installation begins after spring housing installation.
Pilot
Hole
Spring Housing
Figure 8
7
NOTE
To level plate, place
a right angle square
on the flat portion of
the mounting plate.
Pilot
Hole
Square Mounting Plate
Req .
(2)
(2)
(2)
(2)
(2)
(2)
(1)
FM271 11/19
Advertisement
Table of Contents
