Viavi SmartClass MPOLS-84 Operating Manual page 50

6 L /L T O
OSS ENGTH EST PERATION
D
EFINING A TEST CONFIGURATION
Description
Fiber/Light Source
Type
Test Limit
Cable & Connector
Settings
Test Reference
Method
Pass/Fail Fiber
Selection
50
Use the arrow keys to highlight a setup and press the center
button.
The Edit menu opens:
Description of the test configuration.
The description will be shown in the test configuration list below the
title.
The fiber Type can be configured for Single-Mode or Multi-Mode
measurements.
First select the limit specification/preset from the drop down menu.
Then edit the limit settings:
• Expected Polarity: Select the fiber connection type (see
Check" on page 51).
• Length: Enter the length limit (to change the length unit see
change the length unit:" on page
• Max. Loss: at 1300 nm and 850 nm
Select the cable manufacturer, the cable name and the Connector Type
from the respective list.
See the indicated refractive Index.
Select the reference method: 1 jumper cable or 3 jumper cables (for
further information see
Select/Deselect different fiber numbers for pass/fail testing.
To select/deselect fibers for pass/fail testing
The instrument is in Loss/Length mode.
I
[A]
1. Press the key and tap the [Test
The available test configurations are displayed.
2. Tap and select an entry.
– or –
Use the arrow keys to highlight a setup and press the center
button.
The Edit menu opens.
46).
"Referencing" on page
Configuration]
"Polarity
"To
52).
button.
MPOLx-84/85 (P)