Electrical Adjustment (Chu); Preparation Before Adjustment - Sony DXC-S500 Service Manual

EVR & DSP SETTING
EVR adjustment and DSP adjustment menus on each board
. EVR1: Corresponds to EVR on the FM-84 board
adjustment.
. EVR3: Corresponds to EVR on the PD-106 board
adjustment.
. EVR5: Corresponds to EVR on the SW-1082 board
adjustment.
. EVRC: Corresponds to EVR for CA-46 board
adjustment.
<<EVR & DSP SETTING>>
EVR SETTING
TYPE : EVR1
CH : 1
DATA : 00
DSP SETTING
TYPE : DIRECT
CH : 00000000
DATA : 0000
VALUE & TEST SETTING
Menu for overall camera adjustment
<<VALUE & TEST SETTING>>
ADJ VALUE SETTING
NO. : 00
DATA : 0000
ADJ TEST SETTING
NO. : 00
DATA : 0000
LCD & BVS1 SETTING
Video menu of PD-106 (for LCD) and FM-84 boards
<<LCD & VBS1 SETTING>>
ADJ LCD SETTING
NO. : 00
DATA : 4A
ADJ VBS1 SETTING
NO. : 00
DATA : 007E
DXC-S500 (E)

5-3. Electrical Adjustment (CHU)

5-3-1. Preparation Before Adjustment

1. Connection
Connect equipment as described below.
n
Connect the adjusted CCU and unadjusted CHU.
Pattern box
PTB-500
PTB-700
Lens
Camera cable for DXC-S500
CCU
2. Mode initialization
1. Enter the test mode. (Refer to Section 5-2.)
An adjustment menu is then displayed.
2. Set each operation mode as described below using
buttons on the control panel.
. AE MODE:
SHUTTER:
CAM GAIN:
AE DETECT MODE: MID
. WB MODE:
RED GAIN:
BLUE GAIN:
. CAMERA SETUP menu
GAMMA:
CHU
VIDEO
OUT
TV monitor
75 Z
terminator
Waveform/
vector monitor
MANUAL
1/30
0 dB
MANUAL
± 0 dB
± 0 dB
ON (MS)
5-3