Connect The Hub To The Distributed Management Console (Optional) - HP AdvanceStack 10Base-T Hub-12 Installation And Reference Manual

Installing the HP AdvanceStack 10Base-T Hubs
5. Connect the Hub to the Distributed
The HP AdvanceStack hubs can be controlled in two ways:
from a PC running the HP Stack Manager software that is supplied
with the hubs
from an ASCII terminal or PC running a terminal emulation (requires
an HP Ethernet SNMP Module to be installed in the hub or in one of
the hubs in the distributed management chain)
The PC serves as a console for an out-of-band management session that
enables you to configure, monitor, and diagnose one hub or a stack of up
to 16 hubs that are chained together. The HP Stack Manager software is
described in chapter 2, "Installing and Using HP Stack Manager".
With the HP Ethernet SNMP Module, the module's console is also used
to configure, monitor, and diagnose one hub or a stack of up to 16 hubs
that are chained together. You can access the console through a terminal
emulator on your PC or through a terminal.
There are three ways to access a hub:
through a direct serial connection
through a modem connection (available for HP Stack Manager or
ASCII terminal only if an HP J6203 Ethernet SNMP Module is
installed in the hub to which the modem is connected)
through the distributed management chain
1-20
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Management Console (optional)