Network Tests; Factory Reset - HP AdvanceStack 10Base-T Hub-12 Installation And Reference Manual

Installing and Using HP Stack Manager

Network Tests

The Network Tests window enables you to perform Ping, IPX, and Link
network tests. These tests are used to verify the connection between the
hub and a specified network device. The devices tested must support the
test(s) by being able to send the appropriate response packets.
HP AdvanceStack 10Base-T hubs support all of these tests.
The Ping test sends Internet Control Message Protocol (ICMP) Echo
Request ("ping") packets to another node with the specified IP address
and waits for Echo Response packets in return.
The IPX test sends IPX test packets to the specified IPX device and
waits for an IPX test packet in return.
The Link test sends IEEE 802.2 Test command packets and waits for an
IEEE 802.2 Test response packet in return.

Factory Reset

When you install an HP Ethernet SNMP Module in your hub, the Reset
function in HP Stack Manager offers an additional reset option, Factory
Reset. A factory reset resets the hub's configuration, except the IP
configuration, to the factory default values. The factory reset also
causes the hub to perform its self-test, and then causes the results listed
below:
all network ports are enabled
link beat is enabled for all the 10Base-T twisted-pair ports
hub counters are reset to zero
a configured password is deleted
the system name, system location, and system contact are deleted
Thinwatch is disabled
the authorized managers list is cleared and the configuration is reset
to "Allow management from any address"
any backup link configuration is cleared; both ports are returned to
the enabled state
the Robust Port Control features are disabled
the IP configuration is not changed
any security configuration is cleared
2-12
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com