HP AdvanceStack 10Base-T Hub-12 Installation And Reference Manual page 31

ThinLAN Connections
To connect a ThinLAN cable to the hub's ThinLAN port:
1. Attach a ThinLAN cable section to one side of a BNC "T" connector.
(Hewlett-Packard offers BNC "T" connectors with insulating covers.
Order product number HP 92227A.)
2. Attach another ThinLAN cable section or a 50-ohm terminator to the
other side of the "T" connector.
3. Attach the "T" connector to the ThinLAN port.
4. Cover the BNC connector with an insulating cover.
To remove a ThinLAN cable, reverse this process.
N o t e
Each ThinLAN cable segment must be terminated using a 50-ohm termi-
nator at each end. In the illustration above, a 50-ohm terminator would
be placed on one side of the BNC "T" connector if that connector is at
the end of the cable segment.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
OR
50-ohm
terminator
BNC "T"
connector
Installing the HP AdvanceStack 10Base-T Hubs
ThinLAN cable
ThinLAN cable
1-17