Communications Settings; Connect/Disconnect - HP AdvanceStack 10Base-T Hub-12 Installation And Reference Manual

Installing and Using HP Stack Manager
Port enable/disable
Reset
Redundant Power Supply (RPS) status (for the Hub-24 and Hub-48)
There is also an extended set of features available only to hubs that have
an HP J2603A or B Ethernet SNMP Module installed. These are
described later in this chapter under "Advanced Features". Features not
available to your hub will be "grayed out" on the HP Stack Manager
menus and/or any associated buttons will not be displayed.
A description of each basic feature follows. For specific information
about how to use a feature, consult the online help system.

Communications Settings

This function is accessed through the "Settings" menu on the HP Stack
Manager main screen. Use this function to define the settings for the
serial communication between the hub and the PC running HP Stack
Manager.
If the hub to which the serial connection is being made does not have
the HP Ethernet SNMP Module installed, this connection can be only a
direct connection at 9600 baud. If the hub has the module installed, the
connection can be direct or through a modem and at a wide range of
baud rates. These expanded connection capabilities are described later
under "HP Stack Manager Advanced Features". The communications
settings can be stored in an individual file for each serial connection.
See the HP Stack Manager online help for more information.

Connect/Disconnect

These functions are accessed through the "Connect" and "Disconnect"
buttons on the HP Stack Manager main screen. Use this function to
establish a connection to the hub from the PC as defined by the current
communications settings.
2-6
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com