Eneo MEB-65M2713M0A User Manual page 12

DAY & NIGHT: COLOR, B/W and EXT, are selectable for DAY/NIGHT switch.
 COLOR: The image is colored in day mode all the time
 B/W: The image is black and white all the time, and the IR led turns on in the poor light
conditions. Under the B/W mode, you can turn on/off the IR led to meet the requirement
of different circumstances and set the value of IR Smart in this menu.
IR Smart: The function is used to adjust the light to its most suitable intensity and avoid
the image from over-exposure.
Level: The IR level value is set from 0 to 15. The higher the value is, the more obvious
effects are.
Area: Set its area parameters as <Position>, <Size> <RET> and <Again> etc.
 EXT: The option allow you set its switch delay time when the mode is switched from
DN or ND
DN (Day to Night) : is used to control the delay time of switching the <Day> to the
<Night> mode. You can set the value from 0 to 60. The smaller the value is, more
quickly the camera switch between the two modes.
ND (Night to Day) : is used to control the delay time of switching the <Night> to the
<Day> mode. You can set the value from 0 to 60. The smaller the value is, more quickly
the camera switch between the two modes.
Adjust/Special: The menu is used to mainly adjust video parameter setting. Its sub-menu has a
bit difference between Fixed and VF version. Details please refer to the above Menu structure.
 NR (Noise Reduction): The 2 DNR function can decrease the noise effect, especially
when capturing moving images in poor light conditions. You can set the below 2DNR
parameters: OFF, LOW, MIDDLE and HIGH
 Sharpness: determines the amount of detail an imaging system can reproduce. You can
set the Sharpness parameters as Auto & OFF. Under the <Auto> mode, you can set its
Level, Start AGC, End AGC etc Its setting value is as follows:
Level value from 0 to 10
Start AGC value from 0 to 255
 Monitor: the option allows you adjust monitor's parameters; you can set its parameters as
<GAMMA>, <Blue Gain> and <Red Gain> etc.
GAMMA: Its parameter covers the <user, 0.45, 0.50, 0.55, 0.60, 0.65, 0.70, 0.75, 0.80,
0.85, 0.90, 0.95, 1.00>, The larger the value is, the darker screen brightness is.
Blue Gain: Set the value from 0 to100
Red Gain: Set the value from 0 to 100.
 LSC: increase the brightness of the image margin. You can set as <ON> and <OFF>,
under the <On> sub-menu, you can adjust the brightness of screen margin.
 Mirror: OFF, MIRROR, V-FLIP and ROTATE are selectable for mirror.
OFF: The mirror function is disabled.
Mirror: The image flips 180
V-Flip: The image flips 180
Rotate: The image flips 180
End AGC value from 0 to 255
0
horizontally
0
vertically.
0
both horizontally and vertically.
11