Table of Contents
Advertisement
3.
Lower the bottom of the stand's mounting plate into the recess until it snaps into place (2).
The latch on the bottom of the mounting plate pops up when the stand is locked in place.
Mounting the monitor head
To attach your monitor to a wall using a swing arm or other mounting fixture, follow the steps in this section
to safely and securely connect your monitor.
IMPORTANT:
third-party mounting solution to the monitor head, use four 4 mm, 0.7 pitch, and 10 mm long screws. Longer
screws might damage the monitor. Be sure that the manufacturer's mounting solution is compliant with the
VESA standard and is rated to support the weight of the monitor head. For best performance, use the power
and video cables provided with the monitor.
Removing the monitor stand
If you decide to use a wall mount instead of the monitor stand that you attached, first remove the stand.
IMPORTANT:
disconnected.
IMPORTANT:
1.
Disconnect and remove all cables from the monitor.
2.
Position the monitor facedown on a flat surface covered by protective sheet made of foam or a clean,
dry cloth.
3.
Push up the latch near the bottom center of the stand's mounting plate (1).
4.
Swing the bottom of the stand up until the mounting plate clears the recess in the monitor head (2).
6
Chapter 1 Getting started
This monitor supports the VESA® industry-standard 100 mm mounting holes. To attach a
Before you disassemble the monitor, be sure that the monitor is turned off and all cables are
HP recommends that two people position and stabilize the monitor.
Hide quick links:
Advertisement
Table of Contents
