Mounting The Monitor Head; Removing The Monitor Stand - HP OMEN 27u User Manual

2. Position the monitor head facedown and attach the stand to the back of the monitor head (1), and then
secure it with the thumbscrews (2).

Mounting the monitor head

To attach your monitor to a wall using a swing arm or other mounting fixture, follow the steps in this section
to safely and securely connect your monitor.
IMPORTANT:
party mounting solution to the monitor head, use four 4 mm, 0.7 pitch, and 10 mm long screws. Longer
screws might damage the monitor. Be sure that the manufacturer's mounting solution is compliant with the
VESA standard and is rated to support the weight of the monitor head. For best performance, use the power
and video cables provided with the monitor.
NOTE: This apparatus is intended to be supported by a UL-listed or CSA-listed wall-mount bracket.

Removing the monitor stand

If you decide to use a wall mount instead of the monitor stand that you attached, first remove the stand.
IMPORTANT:
disconnected.
IMPORTANT:
procedures.
1. Disconnect and remove all cables from the monitor.
2. Position the monitor facedown on a flat surface covered by protective sheet made of foam or a clean, dry
cloth.
3. Loosen the thumbscrews (1), and then swing the bottom of the stand up until the mounting plate clears
the recess in the monitor head (2).
This monitor supports the VESA industry-standard 100 mm mounting holes. To attach a third-
Before you disassemble the monitor, be sure that the monitor is turned off and all cables are
To position and stabilize the monitor, HP recommends that two people perform these
Mounting the monitor head 7