Connecting An Hp Notebook Computer And Installing Drivers To Enable Usb Type-A Docking - HP EliteDisplay E243d 23.8 User Manual

NOTE: The monitor delivers up to 65 W of power over a USB Type-C connection. When connecting the Host
computer via USB Type-C, DC power out does not need to be connected. Do not connect two power sources
(DC power in and USB Type-C) to the host computer. Connect DC power out only when you dock the host
computer using a USB Type-A–to–USB Type-B cable.
If your computer does not have a USB Type-C port, you can use a USB Type-A–to–USB Type-B cable for
docking. Connect the USB Type-B end of the cable to the docking monitor and the USB Type-A end to the
computer.
Connecting an HP notebook computer and installing drivers to
enable USB Type-A docking
This section provides important information about connecting an HP notebook computer and installing
drivers to enable USB Type-A docking.
To use the monitor with a computer, connect a USB Type-B–to–Type-A cable or a USB Type-C–to–Type-A
cable between the computer and monitor and install the DisplayLink USB drivers. The video signal is sent over
the USB cable. The USB cable also enables all of the port replicator functions.
IMPORTANT:
incompatibility issues between drivers and result in no picture on one of the monitors.
18 Chapter 1 Getting started
Do not install more than one set of USB graphics drivers. Doing so can cause software