Table of Contents
Advertisement
accessible to users) and must be installed in an ultimate enclosure that is
manufactured to provide safety. At a minimum, the enclosure shall provide
a degree of protection against solid objects as small as 12mm (e.g. fingers).
This equates to a NEMA/UL Type 1 enclosure or an IEC60529 IP20 rating
providing at least a pollution degree 2 environment. For details about
installing RX3i rack systems, refer to the PACSystems RX3i System Manual,
GFK-2314.
If you need technical help, contact Technical Support. For phone numbers
and email addresses, refer to the back cover of this Guide.
Installation in Hazardous Areas
The following information is for products bearing the UL marking for
Hazardous Areas or ATEX marking for explosive atmospheres:
Class 1 Division 2 Groups ABCD
This equipment is an open-type device and is meant to be installed in
▪
an enclosure suitable for the environment that is only accessible with
the use of a tool.
Suitable for use in Class I, Division 2, Groups A, B, C and D Hazardous
▪
Locations, or nonhazardous locations only.
13
PACSystems™ RX3i 64 MB CPU w/Ethernet Quick Start Guide
GFK-2941K
Advertisement
Table of Contents
