Table of Contents
Advertisement
4.
To toggle the compatibility setting, press the RDSD DNLD button. The
compatibility indication will toggle between the Normal (CPU320) and
CRU320 compatibility patterns each time the RDSD DNLD button is
pressed.
5.
When the desired compatibility setting is displayed, press the RDSD UPLD
button to save the setting and allow the CPE330 to continue its normal
startup procedures with the new setting. The setting is maintained over a
power cycle and firmware upgrade.
Note that with versions of PME that do not have native CPE330 support,
only CPU320 projects can be stored to CPE330s that are in Normal
(CPU320) compatibility mode and only CRU320 projects can be stored to
CPE330s that are in CRU320 compatibility mode. Users of a CPE330 with
PME version 8.60 SIM 8 or later do not need to change this compatibility
setting if the project is converted to a CPE330 application. By factory
default, the CPE330 is set to Normal (CPU320) compatibility mode.
Migration of CPU315 applications to the CPE330 is possible with no upgrade
to PME by converting them to a CPU320 application and storing the project
to the CPE330.
Note that CPE330s with firmware versions 8.45 through 8.60 support
compatibility with the CPU320 and CPU315 only. The compatibility setting
using the RDSD buttons is not supported for these firmware versions.
Beginning with firmware version 8.70, CPE330s support compatibility with
the CPU320, CPU315, and CRU320 using the RDSD buttons to set the
compatibility mode.
20
PACSystems™ RX3i 64 MB CPU w/Ethernet Quick Start Guide
GFK-2941K
Advertisement
Table of Contents
