Set Up; Near Term Cordless 1-Line - Ctm-A2415 - VTech CTM-A2415 Master User Manual

Set up

Near Term Cordless 1-line - CTM-A2415

Program phone settings
In order to program different telephone settings, you have to enter ADMIN mode during system
idle by pressing *7764#MUTE on the handset.
• During ADMIN mode, MUTE key LED on handset, the MESSAGE WAITING LED and SPEAKER
LED on the base will blink.
To quit ADMIN mode with your settings, press OFF key, and you will hear 2 rising beeps to
confirm. To quit ADMIN mode without saving your settings, press OFF key before MUTE key.
Phone settings
Default settings are indicated by asterisks (*).
Some settings have their corresponding Access Keys or Access Codes. After entering the setting
value, press MUTE to confirm. You will hear a confirmation tone. Set another setting after previous
setting is saved.
Setting
Listening volume- Handset
Speakerphone volume -
Handset
Speakerphone volume -
telephone base
Ringer volume - telephone
base
Ringer tone
Flash
RF transmission power -
telephone base
Voicemail voltage detection
• Steady high voltage,
periodic high voltage pulse
and periodic low voltage
pulse detection method
• Line reversal method
• FSK detection method
• Panasonic
Voicemail voltage detection
• Siemens
Access code/ key
00
FLASH
01
• 10
• 11 (Line rev.)
• 12 (FSK)
• 14 (Panasonic)
13
EN - 13
Options
1, 2, 3, 4*, 5, 6
1, 2, 3, 4*, 5, 6
1, 2, 3, 4*, 5, 6
1, 2*, 3
Tone 1*, Tone 2, Tone 3
1 (100ms), 2 (300ms), 3*
(600ms)
1 (low), 2* (middle), 3
(high)
0 (disable), 1 (enable)
0 (disable), 1 (50Hz), 2
(25Hz), 3 (20Hz)
Adjustable by
User and
administrator
User and
administrator
User and
administrator
User and
administrator
Adminstrator only
Adminstrator only
Adminstrator only
Adminstrator only
Adminstrator only