Connection; Near Term Cordless 1-Line - Ctm-2415 - VTech CTM-A2415 Master User Manual

4. To replace the handset cover, align all
the tabs on the handset cover against the
corresponding grooves on the handset,
then firmly push downward until all the tabs
lock in the grooves. Then install the screw.
CAUTIONS
• There may be a risk of explosion if a wrong
type of handset battery is used. Use
only the supplied rechargeable battery
(BT164392/BT264392) or replacement battery
(BT266342). To order a replacement, call
1-888-907-2007.
• FCC ID is shown on the back of the cordless
handset body after the handset cover is
removed.
• Dispose of used batteries according to the
information in The RBRC® seal.

Connection

Near Term Cordless 1-line - CTM-2415

Telephone base installation
The telephone comes ready for desktop use.
1. Install the telephone base as shown below.
2. When the telephone base has been initially
installed, make sure the power adapter is
securely plugged into an outlet not controlled
by a wall switch, and the telephone line cord is
plugged firmly into the power adapter and the
telephone wall jack.
3. Bent a small paperclip and gently insert it
to the Base battery ON pinhole and Handset
battery ON pinhole to turn on the base and the
handset.
• Without turning on the battery, the base and
the handset cannot be charged.
• Charge the base to enable battery backup
feature.
• The battery is fully charged after 12 hours of
continuous charging. For best performance,
keep the cordless handset in the telephone
base when not in use.
4. Press SPEAKER on the telephone base.
Listen for a dial tone, and then press SPEAKER
again to hang up.
CAUTION
Use only the supplied cable and power
adapter. The supplied cable is not designed for
use in any other IT devices. Misuse it on your
other IT devices shall be prohibited. To order a
replacement, call 1-888-907-2007.
EN - 11