Near Term Cordless Accessory Handset & Charging Stand - Ctm-2415Hc - VTech CTM-A2415 Master User Manual

Near Term Cordless Accessory Handset
& Charging stand - CTM-2415HC
Charger base installation
The telephone comes ready for desktop use.
1. Install the charger base as shown below.
• Make sure the power adapter is securely
plugged into an outlet not controlled by a
wall switch.
2. Bent a small paperclip and gently insert it to
the Handset battery ON pinhole to turn on the
handset.
• Without turning on the battery, the handset
cannot be charged.
• The battery is fully charged after 12 hours of
continuous charging. For best performance,
keep the cordless handset in the charging
base when not in use.
3. Press /SPEAKER on the handset. Listen
for a dial tone, and then press
again to hang up.
CAUTION
Use only the supplied power adapter. The
supplied power adapter is not designed for
use in any other IT devices. Misuse it on your
other IT devices shall be prohibited. To order a
replacement, call 1-888-907-2007.
Handset registration
Place the cordless handset on the telephone
base cradle. Handset registration happens
automatically the first time a cordless handset is
placed on the telephone base.
When the registration process completes, the
MESSAGE WAITING LED flashes once and you
hear 3 rising beeps as confirmation.
Each telephone base accommodates up to
4 cordless handsets. When you already have
4 registered handsets, you can replace one
of them by a new handset if any one of the
4 registered handsets is disconnected from
the base. For example, it is out of range, or its
battery is removed or depleted. The previous
registered handset is then deregistered from
the telephone base.
Handset deregistration
When a registered cordless handset is idle,
press *331734#. You hear a confirmation tone
when the deregistration process completes.
Register a handset to another
telephone base
When a registered cordless handset is idle,
place it on another telephone base. This
cordless handset automatically registers to the
new telephone base.
Handset battery charging
/SPEAKER
The batteries must be fully charged before
using the cordless base and the handset for the
first time. The CHARGE LED turns on when the
cordless handset is charging on the telephone
base or charging base. The battery is fully
charged after 12 hours of continuous charging.
For best performance, keep the cordless
handset in the telephone base or charging
base when not in use.
EN - 12