Setup Menu - ADInstruments AD210 User Manual

_______________________________________________________________________________

Setup Menu

1. Press (SETUP) button to enter the Parameter Setting screen.
2. Press or
(1) Time delay before scan.
This delay allows light source to illuminate the solar panel
before scan stars.
(2) Current Range of Scan begin.
The beginning value of current for scan to start.
(3) Current Range of Scan end.
The ending value of current for scan to stop.
(4) Area of Solar Cell or Panel.
Based upon the input area and irradiance, this unit can
calculate the solar power converting efficiency
(5) Irradiance.
Light intensity in W/m
(6) Single Test Point.
Users can enter a specific value of current here. When users
press the TEST button, this specific value of current will be
simulated and result will be shown.
(7) Alarm of Low Power.
If the maximum power is lower than this value, then a beep sound will be heard.
3. Press or
Press
or press them for few seconds to promptly change setting values.
4. After setting Parameters, press
©Copyright Abacanto Digital SA.
buttons to select the setting items.
2
.
buttons to select the setting items.
or buttons to change the setting values,
button to exit SETUP menu.
Manual de usuario AD210
AD Instruments
18