Dhcp Server; Pbxware Version; Installation; Power Adapter - Grandstream Networks GXP1628 Configuration Manual

To find out the firmware version of your Grandstream phone model open a new browser
window and enter your phone IP address in order to access the phone web administration
interface login screen. Example: http://192.168.1.22.
Login to phone web administration interface with your username and password. Please note,
factory default login details are username: admin and password: admin.

DHCP server

Fully configured and operational DHCP server.

PBXware version

PBXware version 4.1.4.0
In order to find out the PBXware version:
Login to PBXware
Navigate to Settings: About.
On the top of About page is a code similar to this one PBXware Edition: Business, Release:
4.1.4.0 (387597b7), Running: 1.8.32.1-gc-b47edc45, PBXware Proxy v4.1.4 (62b7bcd),
API: 4.1, libmemcached version: 1.0.14, where Release denotes the exact version of your
PBXware.

Installation

This chapter describes how to install and connect the phone to the electrical power and data
network as well as how to apply factory settings.
The following topics are covered:

Power adapter

Power over Ethernet (PoE)

Factory Settings
Power adapter
Connect the Network and Power
Connect the DC plug on the power adapter to the DC port on the phone and connect the other
end of the power adapter into an electrical power outlet.
Connect the ethernet cable between the Internet port on the phone and the network port on a
router or switch to access LAN.
NOTE: If you are using Power over Ethernet (PoE), you don't need to connect the AC adapter.
Make sure the Ethernet cable and router or switch is Power over Ethernet (PoE) compliant.
Power over Ethernet (PoE)
Connect the Network (only)