Housing (L) Block, Cushion Aori-2 (L-Ch) - Sony WH-1000XM3 Service Manual

WH-1000XM3

2-15. HOUSING (L) BLOCK, CUSHION AORI-2 (L-ch)

Note 1: Lubricant (SANKOL) is applied to the cushion AORI
of repair part. Be careful when handling the parts.
5 hanger holder (L)
(See Fig. V)
hole
3 Remove the long path hanger
with hanger holder (L) in the
direction of the arrow.
4 Draw the relay cable out from
the hole of the hanger (L).
How to install the hanger holder (L)
< Fig. V >
Install the hanger holder (L) as shown figure below.
"L" : hanger
holder (L)
Turn over.
22
1 tapping
screw (P2)
(L = 5.0 mm)
1 tapping screw (P2)
(L = 5.0 mm)
6 housing (L) block
Do not remove
these wires.
long path hanger
hanger holder (L)
relay cable
long path hanger
hanger holder (L)
relay cable
long path hanger
housing block (L-ch)
– L-ch –
Do not remove
these wires.
7 cushion AORI
(See Note 1)
2 Open the short path hanger in the direction
of the arrow and pull out the shaft from the
hole of hanger holder (L).
short path hanger
7 cushion AORI
(See Note 1)
housing block
(L-ch)
hanger holder (L)
relay cable
Press.
Sony CONFIDENTIAL
For Authorized Servicer
serial number label
Note 2: If the headband assy is
replaced, paste this serial
number label to a new part.
housing block
(L-ch)
hanger holder (L)
SYS SET