Sub Board-2 (R-Ch) - Sony WH-1000XM3 Service Manual

WH-1000XM3
2-8.

SUB BOARD-2 (R-ch)

• Continued on 2-9 (page 16).
–
rear housing
(R)
rib
connector
1 Remove the MIC wire (white) from the gap between
the rib and the rear housing (R), the gap between
the connector and the rear housing (R), and draw
it out from the under NTC thermistor.
(See Fig. Z)
rear housing
(R)
rib
connector
2 Remove the relay cable from the gap between
the rib and the rear housing (R), the gap between
the connector and the rear housing (R), and draw
it out from the under NTC thermistor.
(See Fig. Y)
rear housing
(R)
rib
connector
3 Remove the MIC wire (black) from the gap between
the rib and the rear housing (R), the gap between
the connector and the rear housing (R), and draw
it out from the under NTC thermistor.
(See Fig. X)
15
–
MIC wire (white)
NTC thermistor
relay cable
NTC thermistor
MIC wire (black)
NTC thermistor
Install each wire other than battery wire as shown
figure below.
Push in the MIC wire (black) to the gap between
the rib and the rear housing (R), the gap between
the connector and the rear housing (R), pass
it through the under NTC thermistor.
MIC wire (black)
rear housing
(R)
rib
connector
Push in the relay cable to the gap between the
rib and the rear housing (R), the gap between
the connector and the rear housing (R), pass
it through the under NTC thermistor.
relay cable
rear housing
(R)
rib
connector
Push in the MIC wire (white) to the gap between
the rib and the rear housing (R), the gap between
the connector and the rear housing (R), pass
it through the under NTC thermistor.
MIC wire (white)
rear housing
(R)
rib
connector
Sony CONFIDENTIAL
For Authorized Servicer
NTC thermistor
NTC thermistor
NTC thermistor
SYS SET