Sub Board-3 (R-Ch) - Sony WH-1000XM3 Service Manual

WH-1000XM3
2-9.

SUB BOARD-3 (R-ch)

• Continued on 2-10 (page 17).
–
4 Remove two solders
of the MIC wire (white).
(See Fig. I)
16
1 Remove thirteen solders
of the relay cable.
(See Fig. L)
–
2 sheet solder protection
(See Fig. K)
3 Remove two solders
of the driver wire.
(See Fig. J)
5 Remove two solders
of the MIC wire (black).
(See Fig. H)
[red/blue/natural]
Install each wire other than battery wire as shown
figure below.
MIC wire (black)
[red]
[natural]
MIC wire (white)
[red] [natural]
driver wire
relay cable
[blue/black]
[blue/natural]
[red/black]
[purple] [blue]
Sony CONFIDENTIAL
For Authorized Servicer
SUB board
SUB board
SUB board
[green]
[natural]
driver wire
SUB board
sheet solder protection
SUB board
[black]
[white]
[red]
[green]
[dark blue]
[red/green]
[natural]
SYS SET