Housing (R) Block, Aori Cushion (R-Ch) - Sony WH-1000XM4 Service Manual

WH-1000XM4

2-12. HOUSING (R) BLOCK, AORI CUSHION (R-ch)

Note 1: When the headband assy is replaced with a new part,
the serial number is changed.
Press the relay cable firmly into the groove.
Press.
Press.
groove
NG
Raised.
groove
Note 3: Lubricant is applied to the aori cushion.
Be careful when handling the parts.
6 Draw the relay cable connector out
from the hole of hanger holder (R).
Note 2: Bend the connector as shown in the figure and
detach it from the hole of the hanger holder (R)
carefully so that the connector does not get
damaged or get detached from the relay cable
connector.
35
relay cable
2 tapping screw
2 tapping screw
relay cable
long path hanger
relay cable connector
3 Remove the long path hanger
with hanger holder (R) in the
direction of the arrow.
– R-ch –
(M1.7 5.0)
(M1.7 5.0)
short path hanger
8 aori cushion
(See Note 3)
8 aori cushion
A
7 hanger holder (R)
hole
5 housing (R) block
Sony CONFIDENTIAL
For Authorized Servicer
1 Remove the relay cable
from the groove.
relay cable
groove
4 Open the short path hanger in the
direction of the arrow and pull out
the shaft from the hole of housing
(R) block.
(See Note 3)
hole
A
SYS SET