Ornament (L) Assy (L-Ch) - Sony WH-1000XM3 Service Manual

WH-1000XM3
Ver. 1.1

2-12. ORNAMENT (L) ASSY (L-ch)

< Fig. N >
Position the driver wire
on top of wire sheet.
deiver wire
NFC wire
wire sheet
Position the NFC wire
L MAIN
on top of wire sheet.
baord
6 Peel the tape (BATT)
adhesive off of the
ornament (L) assy.
q; ornament (L) assy
Note 2: When installing
the ornament (L)
assy, be sure to
refer to page 20.
terminal side
9 Draw the DMIC module
out of the connector (CN604).
Note 1: When removing the DMIC
module from the connector,
remove it so as not to apply
a load to the DMIC module.
Also, make sure that the DMIC
module is not peeled off from
the ornament (L) assy.
(Refer to page 20 for details)
8 wire housing sheet
(See Fig. N)
guide
19
L NFC
deiver wire
baord
wire sheet
5 Peel off the adhesion of
the escutcheon cushion.
7 tape (BATT)
adhesive
L NFC board
guide
ornament (L)
assy (inside)
L NFC board
Paste the wire
housing sheet.
Note 1: Make sure that the DMIC
NFC wire module is not peeled off from
the ornament (L) assy.
(Refer to page 20 for details)
How to install the flexible flat cable
When installing the flexible flat cable, ensure that
the colored line is parallel to the connector after insertion.
OK
Insert straight into the interior.
flexible flat
cable
colored line
connector
– L-ch –
housing block (L-ch)
4 three screws
(P2 10)
1 Peel the cover stopper
adhesive off of the
housing block (L-ch).
2 cover stopper adhesive
Note 3: When installing the screen (L), be careful that it does not
obstruct the acoustic hole of housing block (L-ch).
screen (L)
Sony CONFIDENTIAL
For Authorized Servicer
ornament (L) assy
DMIC module
NG
Insert at a slant.
flexible flat
cable
colored line
connector
4 screw
(P2 10)
1 Peel the cover stopper adhesive
off of the housing block (L-ch).
2 cover stopper adhesive
3 screen (L)
acoustic
hole
housing block (L-ch)
SYS SET