Earpad - Sony WH-1000XM3 Service Manual

WH-1000XM3
Note: Follow the disassembly procedure in the numerical order given.
2-2.

EARPAD

Note 1: The left and right earpads can be removed using the same procedure.
This explanation uses illustrations from the left side.
– –
housing block
Press the earpad to the housing block until
sound that claws of the earpad firmly catch
in the hooks of the housing block from the
six claws position is heard.
Press.
Press.
Press.
Press the earpad from the inside in the
direction of the arrow, and check that six
claws of the earpad are firmly installed to
the housing block.
Press.
10
earpad
Note 3: When the distinguishing the earpad (for L-ch) and earpad (for
Important Note When Replacing the Earpad for L-ch:
The earpad for L-ch of US, CND, AEP, UK, CH, LA are not attached the
Press.
safety label, but when replacing the earpad for L-ch, it will be replaced to
the earpad with the same safety label as for R-ch.
Press.
When replacing the earpad for L-ch of US, CND, AEP, UK, CH, LA, refer
to "IMPORTANT NOTES OF REPLACING THE EARPAD" on page 7.
Press.
Press. Note 4: The printing content of safety label is different depending on the
Refer to the figure below, hold the plate earpad
(hard plastic part internal of the earpad) by hand,
pull it inside until sound that claw of the earpad
remove from the housing block is heard, and
remove the total of six claws in order.
top side
holding
position
1 six claws
three claws
lower side
Note 2: Confirm the positions of the rib before
installing the earpad.
2 earpad
top side
lower side
R-ch), check the presence or absence of a safety label.
– –
top side
destination.
Sony CONFIDENTIAL
For Authorized Servicer
holding position
plate earpad
– –
rib
rib
– –
top side
safety label
SYS SET