Troubleshooting; Safety Notices; Cause And Action - CASO DESIGN VC150 Original Operating Manual

8 Preservation bags
Washing the bagging material in warm water with a mild dishwashing soap, then rinse the
bags well and allow drying thoroughly before reusing
► Bags used to store raw meats, fish or greasy foods can't be reused.
9 Sealing profile (which presses the bag against the sealing bar)
Remove the sealing profile and clean it in warm soapy water.
► The sealing profile should be cleaned thoroughly before installing it again.
► Be careful during re-installation, so that nothing will be damaged and sealing profile is
placed well so that the device can work properly.

18 Troubleshooting

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:

18.1 Safety notices

► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.

18.2 Cause and Action

In the event of a fault, an error code will appear in the display; it describes the cause of the
fault.
Error
Vacuum unit is not
functioning
The first weld on the cut
off piece of the roll is not
being carried out.
Attention
Please note
Attention
Possible cause
Power plug is not plugged in
Defective power cable or
plug
Defective electrical socket
Roll is not positioned
correctly
.
Rectification
Plug in mains plug!
Send device to Customer
Service
Select another electrical socket
Follow the steps in the chapter
"making a bag using the bag roll"
39