Opening Bags / Containers / Winelocks; Safety Information; Cleaning And Maintenance; Cleaning - CASO DESIGN Vacu OneTouch Pro Instruction Manual

DE DE

3.4 Opening bags / containers / WineLocks

EN EN
Push the silicone valve to the side to allow air to re-enter.
IT IT

4 Cleaning and Maintenance

ES ES
NL NL
This chapter provides you with important notices with regard to cleaning and main-
taining the device. Please observe the notices to prevent damages due to cleaning the
RU RU
device incorrectly and to ensure trouble-free operation.
FR

4.1 Safety information

PT
ATTENTION
SV
Please observe the following safety notices, before you commence with cleaning the device:

The item must be cleaned after each vacuuming process.. If the device is not maintai-
TR
ned in a clean condition, can also result in a dangerous condition in the device as well
as in the growth of fungus and bacteria.

Do not use aggressive or abrasive cleaners to clean the device and its parts; the con-
tainers or the WineLocks. Do not use solvents.

Do not scrape o stubborn dirt with hard items.

4.2 Cleaning

Only clean the device and the charging station with a soft, slightly damp cloth. The device
and its parts are not dishwasher-proof.
To clean the drip container, remove it from the housing by carefully pulling it downwards.
Use warm water to clean the drip container and then dry it thoroughly. Following this, reas-
semble the device correctly.

5 Troubleshooting

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:

5.1 Troubleshooting table

The table below will help you to locate and solve small problems.
Error
The device stops during
the vacuum operation
and does not switch on
again.
40 40 CASO Vacu OneTouch Pro
Possible cause
The device sucked in liquid
or powder.
The battery is at.
Action
Stop the vacuum sealing process
by pressing the "On / O " button.
Remove and clean the drip
container as described in the
"Cleaning" section.
Place the device on the charging
station and connect it to mains
power using the USB charger.