Troubleshooting; Safety Notices; Cause And Action - CASO DESIGN VC250 Original Operating Manual

 Inside of the device
To clean the inside of the unit wipe away any food or liquids with a paper towel.
 Inside of the device
The extractable vacuum chamber can be washed under running water or in the
dishwasher – see for this the paragraph "Removing the vacuum chamber".
 Preservation bags
Washing the bagging material in warm water with a mild dishwashing soap, then rinse the
bags well and allow drying thoroughly before reusing
Attention
► Bags used to store raw meats, fish or greasy foods can't be reused.
 Sealing profile (which presses the bag against the sealing bar)
Remove the sealing profile and clean it in warm soapy water.
► The sealing profile should be cleaned thoroughly before installing it again.
► Be careful during re-installation, so that nothing will be damaged and sealing profile is
placed well so that the device can work properly.

18 Troubleshooting

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:

18.1 Safety notices

Attention
► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.

18.2 Cause and Action

The table below helps to locate and resolve minor faults.
Error
Vacuum unit is not
functioning
Please note
Possible cause
Power plug is not plugged in
Defective power cable or plug
Defective electrical socket
.
Rectification
Plug in mains plug!
Send device to Customer
Service
Select another electrical
socket
44