Cleaning; Troubleshooting; Safety Notices; Cause And Action - CASO DESIGN 1380 Original Operating Manual

17.2 Cleaning


Outside of the unit
Wipe the outside of the unit with a damp cloth or sponge and mild dish soap.

Inside of the device
To clean the inside of the unit wipe away any food or liquids with a paper towel.

Vacuum chamber
The extractable vacuum chamber can be washed under running water or in the
dishwasher – see for this the paragraph "Removing the vacuum chamber".

Preservation bags
Washing the bagging material in warm water with a mild dishwashing soap, then rinse the
bags well and allow drying thoroughly before reusing
Attention
► Bags used to store raw meats, fish or greasy foods can't be reused.

Sealing profile (which presses the bag against the sealing bar)
Remove the sealing profile and clean it in warm soapy water.
Please note
► The sealing profile should be cleaned thoroughly before installing it again.
► Be careful during re-installation, so that nothing will be damaged and sealing profile is
placed well so that the device can work properly.

18 Troubleshooting

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:

18.1 Safety notices

Attention
► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.

18.2 Cause and Action

In the event of a fault, an error code will appear in the display; it describes the cause of the
fault.
Error
Vacuum unit is not
functioning
Possible cause
Power plug is not plugged in Plug in mains plug!
Defective power cable or
plug
.
Rectification
Send device to Customer
Service
43