Table of Contents
Advertisement
Installation manual
4.2 Electrical connection of the wall charging station
Proceed as follows for the electrical connection of the
wall charging station:
1. Connect the supply cable to the charging station.
Follow the instructions in chapter 4.1.
2. Place the plastic cover on the full metal housing.
3. Fasten the plastic cover on the sides using the four
metric screws.
4.3 Electrical connection of the charging column
When electrically connecting the charging column, it must
be observed whether or not a foundation plate is integra-
ted in the foundation. If a foundation plate is integrated in
the foundation, proceed as follows:
1. Pull the supply cables through the legs of the char-
ging column.
2. Place the charging column in the right position on
the foundation plate.
3. Fasten the charging station base with the four
supplied M12 nuts.
4. Connect the supply cable according to the power
class (see chapter 4.1).
If no foundation plate is integrated in the foundation, pro-
ceed as follows:
1. Pull the supply cables through the legs of the char-
ging column.
2. Place the charging station on the foundation and
align the charging station.
3. Use the charging station base as a drilling template
and fasten the charging station with four suitable
dowels, washers and screws.
4. Connect the supply cable according to the power
class (see chapter 4.1).
Driving eMobility
5 SAFETY TESTS
After the electrical connection of the charging station,
carry out the necessary safety tests.
• Before commissioning the charging station, check
the effectiveness of the protective measures of the
complete system according to the applicable natio-
nal and local regulations.
• The measuring instruments used must comply with
national regulations.
• Among other things, the Gossen Metrawatt PRO-
FiTEST MTECH+ protective measures tester with
manufacturer no. M520R is required for testing the
charging station. Alternatively, use the Metrel MI
3152 EurotestXC ST. If none of the test devices is
available to you, the missing tests must be perfor-
med by a wallbe specialist partner.
• Enter the result of the test in a test report. A test
report can be obtained from wallbe GmbH upon re-
quest.
• Give the test report to the customer, who will send
it to the manufacturer together with the completed
warranty card.
8/18
Advertisement
Table of Contents
