Table of Contents
Advertisement
Installation manual
1 GENERAL INFORMATION
1.1 Introduction
Before starting the assembly and installation of the
charging station, read this instruction manual carefully
and follow the instructions.
If you have received the installation manual in digital
form, print out the document. Keep the manual stored
at a safe place to have it at hand for any further refe-
rence.
1.2 Intended use
The charging station is designed for charging electric
and plug-in hybrid vehicles according to charging mode
3. The charging station is mounted on a wall or on a
charging column. Any other usage is considered to be
improper and is not permitted.
The charging station wallbe® Pro is suitable for all
electric vehicles with a type 2 connection. The charging
station wallbe® Pro without a firmly attached charging
cable can also be used for electric vehicles with a type 1
connection, if a corresponding adapter cable according
to IEC 62196-2 is used.
Persons who, due to their physical, sensory or mental
abilities or their inexperience or ignorance, are unable
to operate the charging station safely shall not use the
charging station without the supervision or instruction
of a responsible person.
1.3 Target group
This document is intended for qualified electricians and
qualified construction workers (Chapter 3.3).
Assembly and electrical installation of the wallbe® Pro
may only be performed by qualified electricians.
The construction of a foundation for the charging sta-
tion may only be carried out by qualified construction
workers.
Driving eMobility
2 SAFETY
2.1 Signal words
!
WARNING: Indicates a hazard with a medium level
of risk which, if not avoided, could result in serious in-
jury or death.
!
CAUTION: Indicates a hazard with a low level of
risk which, if not avoided, could result in minor or mo-
derate injury.
Note: Indicates additional information, which are not
hazard related.
2.2 Safety instructions
• Observe all local legal regulations for the installa-
tion of charging stations and low voltage systems,
as well as for fire and accident prevention. Pay par-
ticular attention to DIN VDE 0100-722 and DIN VDE
0105-100.
• Ensure that there is no voltage present before start-
ing work.
• Observe the 5 safety rules according to DIN VDE
0105-100.
• Make sure that neither children nor pets come near
the connected charging cable. Never let children play
with the charging station.
• Any changes to the charging station are not permit-
ted. There is a risk of electric shock and damage to
the charging station. Any changes to the charging
station will void the warranty with immediate effect.
• Before commissioning and before each charging
procedure, check the charging station and in parti-
cular the charging cable and contacts for possible
damage.
• Do not use a damaged charging cable. There is a risk
of an electric shock!
• Never repair defective charging cables yourself.
• If the charging station is damaged during assembly
or installation, the charging station must not be put
into operation. Replacement is necessary.
• Check before each charging procedure, whether the
vehicle inlet is damaged. Do not connect a charging
cable to a damaged vehicle inlet.
• Ensure that the contacts of the charging plugs do not
3/18
Advertisement
Table of Contents
