Test With Verified Working Configuration (Hardware Or Operating System); 13. Replace The System Board - HP Elite x2 G8 Maintenance And Service Manual

12. Test with verified working configuration (hardware or operating system)

One troubleshooting technique that can quickly isolate an issue is using a verified working part while testing.
A good example is to use an external keyboard, mouse, or VGA monitor when you have issues with an internal
keyboard, touchpad, or display.
Testing with a verified working AC adapter can identify an error caused by a faulty one. Similarly, testing with a
verified working operating system can determine bad behaviors of the current operating system. See
diagnostics tools on page 76
NOTE: In some situations, more than one item may contribute to a problem.

13. Replace the system board

Only authorized service providers may replace the system board. This should not be considered an initial step
taken to resolve an issue.
Review and perform all steps discussed previously before replacing the system board.
drivers on page
on page 76,
and connections on page 80
unnecessary hardware.
Review Table 7-2 Troubleshooting methodology and general troubleshooting steps on page 69
appropriate troubleshooting steps.
IMPORTANT:
other troubleshooting options.
NOTE: Determine whether a previous service case might be related to the current problem. For example, a
fan detection issue could be caused by a loose connection resulting from previous service.
TIP: Without an RTC battery (3 V coin-cell battery), the computer automatically reboots. This feature is
useful when the power connector cable (between external AC adapter and system board) is defective.
NOTE: Most of the time, effective troubleshooting can prevent a system board replacement.
Situations that can prevent resolution of the issue:
The information provided about the issue omits key details, including any actions taken before the issue
●
occurred.
BIOS, software, and drivers have not been updated.
●
Cables or connections are loose.
●
Technician is unaware of information available from the HP Support website (CA - Customer Advisory).
●
The issue is related to existing or known issues that might be identified in existing support articles.
●
Technician might have omitted steps in the provided repair instructions (for example, Spare Part
●
Replacement Instructions).
Skipping one of steps from Troubleshooting Methodology table results in No Defect Found (NDF)/No
●
Fault Found (NFF)/No Issue Detected (NID) messages.
82 Chapter 7 Troubleshooting guide
for instructions about obtaining and using a Windows-To-Go USB.
72, 7. Status lights, blinking light codes, troubleshooting lights, and POST error messages
8. Hard reset on page 78, and
can resolve many system board issues without requiring the effort of replacing
System board failure is not common. Do not replace the system board until you have tried all
9. Soft reset (Default Settings) on page
Non HP
4. Update BIOS and
79, or 10. Reseat cables
for