Important Information; Conformity With European Regulations8; Degrees Of Protection Provided By Enclosures; Limitations Of Use - TESY EVHP Series Manual

4. IMPORTANT INFORMATION

4.1 Conformity with European regulations
The EVHP heat pump is a device intended for domestic
use in conformity with the following European directives:
•
2012/19/UE Directive on general product safety;
•
2011/65/RoHS Directive on the restrictions of use of
certain hazardous
electronic equipment (RoHS);
•
Directive 2003/108/CE
electric and electronic equipment (RAEE);
•
Directive 2004/108/CE
compatibility (EMC);
• Directive 2006/95/CE – Low Voltage Directive (LVD).

4.2 Degrees of protection provided by enclosures

The degree of protection of the equipment is equal to:
IPX4.

4.3 Limitations of use

WARNING!: This device has not been
designed, nor is it intended for use
within hazardous environments (due to
the presence of potentially explosive
atmospheres
standards or with a requested IP level
exceeding that of the equipment) or in
applications that require (fault-tolerant,
fail-safe) safety characteristics such as
in circuit-breaking
technologies or in any other context in
which the
application could cause death or injury
to people or animals or serious damage
could be caused to objects or the
environment.
N.B.: In
breakdown or fault, this could cause
damage (to people, animals and goods).
It is necessary to arrange for a separate
functional
alarm functions in order to avoid such
damage being caused. Moreover, it is
necessary to arrange for a back-up
service in case of failure!

4.4 Operating limits

The above mentioned device is intended to be used
exclusively for the heating of domestic hot water within the
foreseen limitations of use (paragraph 3.1).
The equipment can only be installed and started up for the
intended use within closed heating systems in conformity
with the EN 12828 standard.
substances in electric
- Hazardous substances in
- Electromagnetic
–according
to
systems and/or
malfunctioning of
the event of a product
monitoring system
and

4.5 Fundamental safety rules

ATEX
•
The device must be used by adults;
•
Do not open or disassemble the device when this is
connected to the power supply;
•
Do not touch the device with wet or humid body parts
when barefoot;
•
Do not pour or spray the device with water;
an
•
Do not stand, sit and/or rest anything on the device.

4.6 Information on coolant used

This device contains fluorinated greenhouse gas included
in the Kyoto protocol. Do not discard such gas into the
environment.
Coolant type: HFC-R134a.
5. INSTALATION AND CONNECTION
with
WARNING! Installation, commissioning
and maintenance of the device must be
performed by qualified and authorised
personnel. Do not attempt to install the
device yourself.

5.1 Preparation of the installation site

The installation of the device must be carried out in a
suitable place in order to allow the normal use and
adjustment operations,
extraordinary maintenance to be performed. Therefore it is
important to allow for the necessary working space by
referring to the dimensions
Shown in Fig. 2.
Page 8 of 28
N.B.: The manufacturer shall not be
held responsible
circumstances in the event that the
equipment is used for other purposes
than for which it has been designed and
as regards any installation errors or
equipment misuse.
WARNING! It is forbidden to use the
device for purposes other than those
intended. Any other use is to be
considered improper and therefore not
allowed.
N.B.: During the
construction stage of the systems,
current local rules and provisions are
complied with.
together with
under any
design and
ordinary and