Construction Characteristics - TESY EVHP Series Manual

3 CONSTRUCTION CHARACTERISTIC
1 Heat pump.
2 Control panel.
3 Enclosure in embossed ABS.
Steel tank (boiler) with double enamelling
4
(capacity: 160; 200; 260 litres).
5 Upper boiler probe.
6 Lower boiler probe.
7 Coolant recharge.
8 Ambient air recirculation fan.
9 Throttle valve.
High-efficiency
10 quantity of fluid put into this is regulated by an
appropriate thermostatic valve.
11 Air inlet (∅ 160 mm).
12
Air outlet (∅ 160 mm).
13 Hermetically-sealed rotary compressor.
14 Replaceable magnesium anode.
(1.5 kW – 230 W) Electric heating element
15
16 Condenser pump discharge line.
17 Condenser return.
18 Replaceable magnesium anode.
Hot water outlet connection joint (G 1").
19
Recirculation fitting (G ¾").
20
21 Inlet, coil fitting for solar thermal power system
1/4 2
(G 1"
; 1 m exchange surface).
Condensates drain (G 1/2").
22
Outlet, coil fitting for solar thermal power sys-
23
1/4
tem (G 1"
; 1 m
Cold water inlet connection joint (G 1").
24
25 50 mm polyurethane insulation.
26 Automatic resetting safety pressure switch.
Coil fitting for auxiliary heat source (G 1"
27
2 )
0.6 m surface - Inlet
Coil fitting for auxiliary heat source (G 1"
28
2 )
0.6 m surface - Outlet
29 Air inlet filter.
finned evaporator.
2
surface).
1/4
29
1
2
The
3
12 10 11
8
;
1/4
;
14
15
16
17
18
25
Page 6 of 28
13
4
5
6
9
7 26
19
28
22
23
27
20
21
24