Save Options & Storage - FLIR E Series User Manual

22
Camera settings
22.4 Save options & storage
8
• Inspection route : This setting is used to activate and configure the Inspection Route
function. For more information, see section 17 Inspection Route.
• Preview image before saving: This setting defines if a preview image will be displayed
before the image is saved.
• Add annotation after saving: This setting defines if an annotation tool will be displayed
when the image has been saved. Available options are:
◦ Save: No annotation tool will be displayed.
◦ Save & add note: The note annotation tool will be displayed.
◦ Save & add table: The table annotation tool will be displayed.
◦ Save & add voice annotation: The voice annotation tool will be displayed.
◦ Save & add sketch: The sketch annotation tool will be displayed.
◦ Save & add any annotation: The annotation tool menu will be displayed.
• Image resolution 9 : This setting defines the resolution of the images captured by the
camera. Available options are Normal and UltraMax. For more information, see sec-
tion 8.1.4 About UltraMax.
• Video compression: This setting defines the storage format for video clips. Available
options are:
◦ Mpeg (*.mpeg): MPEG recordings cannot be edited after the file has been saved.
◦ Radiometric storage (*.csq)
ported by FLIR Systems software. The file does not include any visual image infor-
mation. With this setting, only Thermal image mode is supported when recording
video.
• Photo as separate JPEG: For the Thermal MSX, Thermal, and Picture in picture im-
age modes, a visual image is always saved in the same JPEG file as the thermal im-
age. Enabling this setting saves an extra low-resolution visual image as a separate
JPEG file.
• Digital camera: This setting is used to turn on/off the digital camera. Turning off the
digital camera can for example be required in restricted areas and in confidential (e.g.
doctor/patient) situations. When the digital camera is off, the images modes Thermal
MSX and Picture in picture are disabled.
• Measure distance 11 : This setting defines if the laser distance meter will be used to
measure the distance when an image is saved. With this setting, the Object distance
parameter (see section 12.5 Changing the measurement parameters) in the image
data is automatically updated with the measured distance when an image is saved.
(There is no effect on the Object distance setting in live mode.)
• File naming format: This setting defines the naming format for new image/video files.
The setting has no impact on already saved files in the archive. Available options are:
◦ DCF: DCF (Design rule for Camera File system) is a standard that specifies the
naming method of image files (and much more). With this setting, the name of a
saved image/video file will be FLIRxxxx, where xxxx is an incremental counter. Ex-
ample: FLIR0001. (When the counter has reached 9999, the file name will change
to IR_yyyyy.jpg.)
◦ Date prefix: A prefix will be added to the filename, including the date and the text
"IR_" for images and "MOV_" for videos. Examples: IR_2015-04-22_0002 and
MOV_2015-04-22_0003. The date format will follow the Date & time format setting,
see section 22.5 Device settings.
Note With the Date prefix setting, the files may not automatically be detected by
third-party applications.
8. This item is dependent on the camera model.
9. This item is dependent on the camera model.
10. This item is dependent on the camera model.
11. This item is dependent on the camera model.
#T810587; r. AA/74078/74713; en-US
10 : A CSQ file supports full radiometry but is only sup-
93