Removal Of Temporary Transport Beams; Machine Installation; Connection To The Mains; Arm Release In Arg 380, 400, 500 Plus S.a - Pilous ARG 330 SAF Instruction Manual

3.2. Removal of temporary transport beams and fixation of the machine
Use a pallet truck to lift the machine and place it directly on the desired location in the workplace. Unscrew the bolts that hold the
machine in place and remove the transport beams. Lift the machine with a crane, remove the beams and lower the machine onto the
floor. Level the machine by laying metal sheets under its legs, possibly anchor to the floor. Remove the anticorrosion film and dust
from sliding surfaces and apply oil. Ensure connection to the mains (see section 3.4.). Pour the coolant (maximum 30 litres) into the
tank; the fluid will gradually flow into the container in the base. The hydraulic unit is fitted with two filling holes that are covered by red
transport caps during the transport (see section 6.5.). The cap that is more accessible to the operator has to be removed and
replaced by a filling cap, otherwise a risk of making the entire system inoperable arises, along with the risk of pump damage.
When handling coolants, risks linked to hazardous substances cannot be avoided. Observe the national norms
and recommendations/manufacturer's or your company's operating instructions related to safe handling of
coolants.

3.3. Machine installation

Protect the machine against humidity, rain and dust!
The machine may be operated in the ambient temperature between + 5° and + 40°C. The average air temperature must not exceed +
35°C within 24 hours.
+ 35°C. In temperatures below + 5°C the conventional coolants should be replaced by coolants designed for such temperatures. In
addition to that, replace the oil in the hydraulic unit for a less viscous one.

3.4. Connection to the mains

Make sure that the grid voltage, the voltage protection and the connection voltage comply with the power requirements specified in
the point 2. Technical parameters. Only current protection of S characteristics can be installed (for a frequency converter). When
connecting the machine to the mains (3 NPe 50 Hz, 400 V, TN-S), mind the colour coding of wires carefully: L1 brown, L2 black,
L3 grey, N blue, PE yellow-green. Improper connection of the neutral or PE wires may lead to damage of the electrical
equipment or to an electric shock! Connect the power cable to a protected 16 A socket, in case of direct connection to the mains it
is necessary to fit the supply with a lockable MAIN SWITCH. If the motor rotates in an incorrect direction, swap the conductors
L1 brown and L2 black on the machine junction box.
Failure to observe the aforementioned may lead to incorrect rotation of the bandsaw and the coolant pump.
Danger: Damage to the machine!
3.5. Arm release in ARG 380, 400, 500 plus S.A.F.
The arm is secured against movement for transport. Demount the yellow console by unscrewing the screws/helix in order to release
the arm. In ARG 400 plus S.A.F. unscrew also the clamp and the handle of the console and fasten it into the hole of the helix. In case
of transport, secure the arm against movement the same way.
ARG 400 plus S.A.F.
Such operations must be carried out only by persons with electrician qualifications!
ARG 380 plus S.A.F., ARG 500 plus S.A.F.